Description
Lost in HCM offers the Snap-on TQSS4FUA torque driver under its plain code, U.S. Follow-up Torque Driver. Next to it sits the TQSS4FUAC listed with Chart, the version for buyers who want a document in the box. The tool itself does not change, so this guide sorts out the paperwork side.
Plain code, same tool
In catalog CAT1500i, Snap-on prints the TQSS4FUA in its US Reading driver table for 1/4 inch drive. Below the table, a note says these codes come without a certificate of calibration. A C on the end orders the certified version. Therefore the TQSS4FUAC follows that rule, and Lost in HCM calls its extra item a chart.
Three buyers weigh the TQSS4FUA
The plant with a torque bench
A site with its own tester checks a new 50 in-lb driver in a few minutes. Then it files its own record. So the plain Snap-on TQSS4FUA torque driver fits, and the saving goes elsewhere.
The contract manufacturer facing an audit
An EMS supplier may need a record for every torque tool before a customer visit. In that case, the TQSS4FUAC brings the chart with it, so no lab trip delays the audit.
The repair shop on a budget
A small service team may only cross-check the TQSS4FUA against a master tool now and then. For that use, the plain code keeps the cost down.
Snap-on TQSS4FUA torque driver figures in CAT1500i
| Item | CAT1500i p.336 |
|---|---|
| Model | Stubby follow-up, two needles |
| Length | 5-1/4 in |
| Range | 50 in-lb |
| Increments | 1 in-lb |
| Case | PB47 |
Compared with the TQSS4FUA, the standard TQS4FUA carries the same scale on an 8-11/16 inch body. Meanwhile, 50 in-lb equals about 5.65 N·m, so this stubby handles firm small screws in tight housings.
Sourcing the Snap-on TQSS4FUA torque driver for your team
Lost in HCM supplies this driver in Vietnam and quotes each order. Write TQSS4FUA without a C if you want the plain version. From there, request a TQSS4FUA quote from Lost in HCM for your site. Our torque screwdrivers list shows other ranges, and the SMK Vietnam team can help.
Stubby follow-up questions on the TQSS4FUA
Why buy a stubby follow-up at 50 in-lb?
The short TQSS4FUA body reaches cramped screws, and the second needle keeps the peak until you read it.
What comes after the TQSS4FUA in range?
It is the TQSS6FUA, a stubby follow-up that reads to 75 in-lb, versus 50 in-lb on the TQSS4FUA.
Can we order the chart later?
The chart version is a separate code, the TQSS4FUAC. Otherwise, your own lab can verify the plain driver and keep the record.
Reviews
There are no reviews yet.