Snap-on TESI20 Torqometer, Newton Meter Basic Dial Wrench, 3/8″ Drive, 20 N·m

Description

Here you see the Snap-on TESI20 Torqometer in its plain form. Lost in HCM’s listing reads “Newton Meter Basic – TESI20” and mentions no certificate. When a certificate must arrive with the tool, the right page is the certified TESI20C dial wrench. Otherwise the two match, from the 3/8 inch drive to the 20 N·m dial.

Five questions that pick the code

• Does your quality manual ask for a certificate before a gauge enters service? If yes, order the TESI20C.
• Is an audit due before you could book a lab check? Then the C code avoids a gap in the record.
• Do you own a torque tester that covers 20 N·m? If so, the TESI20 lets you verify it in-house.
• Will an outside lab check every new tool anyway? In that case, a factory certificate adds little.
• Is the wrench a spare for training or rework? Then the plain code usually fits the budget.

Snap-on supports this choice directly. Its catalog notes that wrenches in the Newton Meter chart ship without a certificate, and that adding C to the stock number orders one.

What stays the same on the Snap-on TESI20 Torqometer

Because the row is shared, a TESI20 and a TESI20C read alike on the bench. Also, the same row offers the TESI20FU with two needles and the TESI20L with a signal light.

In-house verification with the TESI20

If you buy the plain code, verify it before first use. First, check that the needle rests on zero. Next, load the wrench at a few points across the useful part of the scale on your tester. After that, log the readings against the asset number. Snap-on’s UK brochure flags readings below 20% of full scale, so start your checks at 4 N·m or above. Snap-on also states that periodic recalibration is necessary, so add the TESI20 to your recall list.

Where to source the Snap-on TESI20 Torqometer

Lost in HCM supplies the TESI20 across Vietnam and issues each quote. To begin, request a quote from Lost in HCM and name the exact code. You can also see the full torque wrench category or contact SMK Vietnam with questions. Once the Snap-on TESI20 Torqometer arrives, stay within its rated torque and never use it to loosen a stuck fastener.

Questions on the plain TESI20

Does the TESI20 come with any chart?

Lost in HCM’s listing names no chart or certificate for this code. If you need one in the box, the TESI20C is the code to order.

Which case fits the TESI20?

Snap-on’s table lists the PB9 storage case for this size. Check with Lost in HCM that the quote covers the case.