Snap-on TEC25FA Torqometer, U.S./Metric Basic Dial Wrench, 3/8″ Drive, 25 ft-lb / 350 kg·cm

Description

On this page, the Snap-on TEC25FA Torqometer appears as TORQOMETER U.S./ Metric Basic – TEC25FA, with no chart in its name. Lost in HCM lists the charted twin separately, and you can find it on the TEC25FAC page, the with Chart code of this wrench. Snap-on prints one row for the pair. So any difference between them comes down to documents.

TEC25FA versus TEC25FAC at the receiving desk

Snap-on’s combination table carries a short note. Wrenches in the chart do not include a certificate of calibration, and certificate versions are available. Elsewhere on its Torqometer pages, the catalog adds that the C suffix marks those models. Here is how each code tends to move through incoming inspection.

• The plain TEC25FA arrives as a tool only. Receiving logs it, and then a lab checks it before release.
• The charted TEC25FAC arrives with its paperwork. As a result, receiving can file that record and release the wrench sooner.

When the Snap-on TEC25FA Torqometer is the sensible order

A plant that runs its own torque tester gets little from a factory document, because its technician will verify the wrench anyway. Likewise, a site with a regular outside lab contract can add the TEC25FA to the next batch. In both cases, the plain code keeps spending on the tool itself. On the other hand, a line that must start next week with no lab slot should take the charted code.

TEC25FA catalog row

As a Basic model, the wrench has one needle that shows the torque achieved. The same row lists the TEC25FFUA follow-up and the TEC25FLA signal models. Snap-on places all three in its Combination US/Metric Reading/Standard 2% Accuracy table.

Two scales, one needle

Some Asian drawings still give small torque values in kg·cm. Because the TEC25FA dial shows kg·cm beside ft-lb, the operator reads either unit directly. For N·m, 350 kg·cm comes to about 34.3 N·m. Also, the UK brochure places the Standard band from 20% of full scale, so start at 5 ft-lb or 70 kg·cm.

Ordering the Snap-on TEC25FA Torqometer

Lost in HCM supplies Snap-on Torqometers in Vietnam and prepares the quotes. Write TEC25FA on the request, so the plain code ships, and add the quantity. Then request a quote from Lost in HCM, compare other torque wrenches, or contact SMK Vietnam.

Receiving FAQ for the TEC25FA

Can receiving release the TEC25FA without a document?

That depends on your own procedure. Many plants first send a plain wrench to their lab, then release it with an internal record.

Is the TEC25FA a follow-up wrench?

No. It is the Basic model with one needle. The follow-up version in the same row is the TEC25FFUA.

What storage case does Snap-on list?

Snap-on names the PB9 case in the TEC25FA catalog row.