Description
Buyers who search for the Snap-on TE1003L torque wrench will find two codes for one tool. In this case, the listing is the plain TORQOMETER U.S. Light Signal – TE1003L. Its twin is the TE1003LC, listed with Chart. Because Snap-on prints a single row for both, the price gap reflects paperwork rather than hardware.
Read the code before the price
A purchase request that says “1,000 ft-lb dial wrench” leaves the key detail open. Snap-on’s CAT1500i note says its chart wrenches ship without a certificate of calibration. In contrast, a certificate model needs a C on the end of the stock number. Therefore, the code you write decides what lands at receiving, so settle it before you compare quotes.
A quick checklist for the Snap-on TE1003L torque wrench
- Audit trail. Does your quality plan need a document on file before first use? If yes, lean to the TE1003LC.
- Incoming inspection. Will receiving release a gauge with no paperwork? If not, the charted code avoids a hold.
- In-house verification. Do you own a tester that reaches 1,000 ft-lb? If so, the plain TE1003L lets your lab write the first record.
- Budget. Would the money do more as sockets, a spare or an outside lab visit? Then the plain code frees it.
A yes on either of the first two points usually points to the charted wrench. Otherwise, the TE1003L covers the job.
What the TE1003L brings to the joint
Snap-on files this wrench under US Reading/Standard 2% Accuracy. It reads 1,000 ft-lb in 10 ft-lb steps on a 1 inch square drive. Overall length runs 66-13/16 inches, while the width comes to 3-9/16 inches. Then the head depth, without the drive, adds 2-1/32 inches. The catalog also notes a separately packed 92TQPA 4-foot tubular extension handle. Meanwhile, the signal light flashes when the pull reaches the target, which helps when the dial sits at an awkward angle.
Working band
Snap-on’s UK brochure gives the Standard grade from 20% of full scale to full scale. On the Snap-on TE1003L torque wrench, that means 200 ft-lb and above. For example, a 600 ft-lb joint sits near the middle, where the brochure suggests you work. As a guide, 1,000 ft-lb equals about 1,356 N·m.
Requesting the Snap-on TE1003L torque wrench
Lost in HCM supplies Snap-on Torqometers across Vietnam and writes each quote. Put TE1003L on the request, and ask Lost in HCM to confirm the extension handle. Then request a quote from Lost in HCM, review our torque wrench category, or contact SMK Vietnam.
TE1003L cost questions
Is the plain code always cheaper overall?
Not always. If you must send the wrench to an outside lab before use, add that fee and the downtime to the TE1003L price.
Can we switch to the charted code later?
The code stays fixed at purchase. However, your lab or an outside lab can check a plain TE1003L at any time.
Does the TE1003L read N·m?
No. It reads ft-lb only. So convert metric specs before the pull, at about 1.356 N·m per ft-lb.
Reviews
There are no reviews yet.