Description
Wafer fab tools pack many small screws into tight chambers and frames. The Snap-on TQSS025FUAC torque driver helps equipment engineers check those screws with care. It is a stubby Torqometer dial driver with a U.S. scale, a 1/4-inch drive and a follow-up needle. Its name also says it comes with a chart.
Stubby reach inside process tools
A short body fits where a full-length driver will not. For example, think of screws behind a gas panel or inside a robot cover. The stubby TQSS025FUAC lets the engineer turn the screw without tilting the bit. So the reading stays true, and the screw head stays intact.
Peak memory on the Snap-on TQSS025FUAC torque driver
The follow-up needle rises with the main pointer and stops at the highest value. Then the engineer can pull the driver out of a dark chamber and read it under good light. Reset the needle before the next screw. Otherwise, the old peak will carry over into the next record.
Maintenance jobs in a fab
- Cover, bracket and shield screws during preventive maintenance.
- Sensor and fitting screws after a part swap.
- Checks on small fasteners that a vendor field engineer installed.
- Kit checks before a tool restarts after a long PM.
Many US-built tools quote screw torque in inch-pounds or inch-ounces. So the U.S. dial on the TQSS025FUAC matches those manuals directly.
Scale, drive and accuracy
Lost in HCM lists the TQSS025FUAC under US Reading Standard/2% Accuracy, in its 1/4-inch drive torque driver group. Snap-on rates that Standard grade at 2% of the reading over the top 80% of the scale, in both directions. We could not find this model with its C suffix in Snap-on’s catalogs. So the range and steps stay off this page, and Lost in HCM can confirm them.
Handling near clean process areas
Follow the fab’s rules for tools that enter the cleanroom or the subfab. Wipe the Snap-on TQSS025FUAC torque driver before use and keep it bagged while it sits idle. Also use bits that fit the screw heads well, because cam-out can scratch nearby parts. Then add the driver to your tool calibration list.
Order the Snap-on TQSS025FUAC torque driver
SMK Vietnam lists this driver for its partner Lost in HCM, which supplies it in Vietnam. To price a driver for each PM kit, request a quote from Lost in HCM. You can also compare torque screwdrivers, check snapon.com, or contact SMK Vietnam about your PM kits.
Fab maintenance FAQ for the TQSS025FUAC
Why use a stubby driver in a fab?
It fits short gaps inside chambers and frames, where a long driver would tilt.
Is there a metric scale on the TQSS025FUAC?
Lost in HCM lists it under US reading only. Choose a combination model if you also need metric units.
What should I ask about the chart?
The source gives no detail on the chart. So ask Lost in HCM what it shows before you place an order.
Reviews
There are no reviews yet.