Snap-on TEX3005TFU Torque Wrench, Torqometer U.S. Follow-up T-Handle, 3,000 ft-lb, 1-1/2″ Drive

Description

Sugar mills in Tay Ninh, Thanh Hoa and the Mekong Delta crush cane hard for a few months, then rebuild during the off-season. That rebuild covers mill roll housings, pinion gearboxes, cane knives and shredder rotors, all held by very large bolts. The Snap-on TEX3005TFU torque wrench gives the fitting crew a measured pull on those joints. It is a U.S.-reading T-handle Torqometer head, and a follow-up needle keeps the highest value.

Off-season rebuilds with the Snap-on TEX3005TFU torque wrench

Mill roll bearings and housings take heavy shock loads from wet, fibrous cane. So the bolts that hold them need a recorded value, not a guess. With this head, the fitter pulls to the maker’s figure, then reads the held needle after easing off. As a result, the mill engineer can sign off each housing before the next crushing season starts.

TEX3005TFU line in the U.S. T-handle table

Snap-on lists these values in the U.S. Reading T-handle table of catalog CAT1500i. In that row, the light-signal column shows a dash, so the TEX3005TFU has no U.S. signal twin. Per the same table, the base code carries no certificate, and adding a C orders the certificate version.

Why the mill log likes two needles

One needle follows the load while the other stays at the peak. Therefore the fitter does not need to read the dial during a hard two-hand pull. Instead, the TEX3005TFU shows its result after the pull, when the fitter can stand back and read it calmly. Then the value goes straight onto the rebuild sheet.

Load band of the TEX3005TFU

Snap-on guarantees this grade within 2% of reading from 20% of full scale to full scale. On this head, the band runs from 600 ft-lb up to 3,000 ft-lb, or about 4,070 N·m. Bolts below 600 ft-lb call for a lighter head, such as the 1,500 ft-lb TEX1503TFU. Never exceed full scale, and never use the head to free a seized bolt.

Safe pulls with the Snap-on TEX3005TFU torque wrench

A 66 inch extension handle gives real leverage, so plan the pull before you start. Set the reaction point, brace your feet, and keep the head square to the bolt. Also clear sugar residue and water from the dial guard after each shift, because sticky deposits hide the needles. Store the head dry between seasons, and recalibrate it before the next rebuild.

Request the TEX3005TFU through Lost in HCM

Lost in HCM supplies this head and sends the quote. For a mill maintenance department, request a quote from Lost in HCM. Lighter and heavier heads appear in the torque wrenches category at SMK Vietnam, while snapon.com covers the maker side. Questions about this page? Please contact SMK Vietnam.

TEX3005TFU sugar mill FAQ

Does Lost in HCM tag the TEX3005TFU for an industry?

Yes, its listing tags hydroelectricity. Still, the head fits any heavy joint inside its range, such as mill rolls and big gearbox feet.

Which handle comes with the TEX3005TFU?

Snap-on lists the 83TQP T bar and the 87TQP extension handle as options. Ask Lost in HCM which one your quote includes.

Is there a light-signal version of the TEX3005TFU?

Not in the U.S. table. If you want a lamp at 3,000 ft-lb, Snap-on lists the TEXC3005TL with U.S. and metric scales.