Snap-on TESI30LC Torque Wrench, Newton Meter Light Signal Torqometer, 3/8″ Drive, 30 N·m, with Calibration Certificate

Description

Electric vehicle and energy storage plants join battery modules with busbars, and every busbar bolt carries current. A loose one can heat up, while an overtightened one can crack a terminal. The Snap-on TESI30LC torque wrench helps engineers check those joints in newton meters. A lamp flashes at the target, and the product name adds a calibration certificate.

Why a lamp suits pack assembly

Battery lines demand calm, careful work, and operators often wear thick gloves. Because of that, watching a fine scale for hours is tiring. With the TESI30LC, a light flashes when the pull reaches the target torque. So the operator can stop on cue and then read the needle for the record.

TESI30L figures

Snap-on lists these values in its newton meter table in catalog CAT1500i, as well as the case code. Per the catalog, a C at the end of the stock number orders a certificate of calibration. That is why this listing carries the TESI30LC code, and why the paperwork comes with it.

Pack joints for the Snap-on TESI30LC torque wrench

• Busbar to terminal bolts, where the cell maker gives a value in range.
• Module hold-down bolts in the pack tray.
• Contactor and fuse terminal bolts in the junction box.
• Cooling plate and bracket bolts on storage racks.

The source does not describe this wrench as insulated. So follow your plant’s rules for any work near live parts.

Grade and lower limit

Lost in HCM lists the TESI30LC under Newton Meter Reading/Standard 2% Accuracy. Snap-on defines that grade from 20% of full scale to full scale, which starts at 6 N·m here. Therefore, smaller cell tab and sensor screws need a torque screwdriver instead.

Records and care for the TESI30LC

Battery customers often ask for traceable torque data. So file the certificate with your line records, and note the wrench on each audit sheet. Also check the lamp before each shift. Keep the wrench in a case, away from heat and dust. Then send it for outside calibration on the cycle your quality plan sets.

Order the Snap-on TESI30LC torque wrench

Battery and EV plants can source this wrench from Lost in HCM, the SMK Vietnam partner that handles supply. To plan your next line audit, request a quote from Lost in HCM. Lighter and heavier dials sit in the torque wrenches section. Also see snapon.com, or contact SMK Vietnam about line needs.

Battery line questions

Is 30 N·m enough for busbar bolts?

It depends on the cell and busbar design. Check the maker’s table, since this dial reads up to 30 N·m.

Is the TESI30LC certificate part of the order?

Yes. The product name says the wrench comes with a calibration certificate. Ask Lost in HCM what details it shows.

Does it read in ft-lb?

No. This model reads in newton meters only, in 1 N·m steps.