Snap-on TER352A Torque Wrench, US/N·m Basic Torqometer, 3/4″ Drive, 480 N·m / 350 ft-lb

Description

You are looking at the plain code, “U.S./ New. Met. Basic – TER352A”, as Lost in HCM names it. In short, the Snap-on TER352A torque wrench ships without the certificate that its twin carries. That twin is the TER352AC Torqometer with a calibration certificate. Both sit on one catalog row, so pick by process, not by hardware.

No suffix, no certificate: the TER352A rule

Snap-on keeps this simple. Its CAT1500i note says listed wrenches include no certificate, while a C suffix on the code brings one. Therefore the TER352A gives you the bare tool. By contrast, the TER352AC adds a document for your file.

An incoming check plan for the Snap-on TER352A torque wrench

Plants with a large torque tester can build their own record in a few steps:

• First, log the serial number and give the wrench an asset tag.
• Next, confirm that the needle rests on zero before any load.
• Then test it at points across the upper part of the scale, in both directions.
• Finally, file the result and set a due date in your recall system.

Once that record exists, the plain TER352A serves daily work just as the certified code would. Meanwhile, the money you save can go toward sockets or adaptors.

When the TER352AC still wins

Some sites have no tester big enough for 480 N·m. Others face a customer audit before a lab could return the tool. In either case, the certificate code removes the wait.

TER352A numbers from the Snap-on table

A single needle on this Basic dial shows the torque reached. Snap-on prints the row in its Precise 1% Accuracy table for combination US and newton meter dials. Also, the row lists the TER352FUA and TER352LA, so buyers can add a second needle or a signal light instead.

Sourcing a Snap-on TER352A torque wrench in Vietnam

Plants across Vietnam buy the TER352A through Lost in HCM, which quotes each order. Name the plain code on the request, so no certificate version turns up by mistake. Then get a price for the TER352A from Lost in HCM. Other drives sit in our torque wrenches section, and you can always contact SMK Vietnam.

TER352A receiving FAQ

Do we need our own tester to use the plain code?

Not always, because a contract lab can test the TER352A for you. However, an in-house tester makes the first check faster.

What should we look at before first use?

Start with the zero point. If the needle sits off zero, set the TER352A aside and ask Lost in HCM for advice.

Is the TER352A suitable for loosening rusted nuts?

No. Snap-on warns against using a Torqometer to break fasteners loose, so use a breaker bar for that job.