Snap-on TECH2Y100 Torque Wrench, Y-Shank Interchangeable Head Techwrench, 5-100 ft-lb

Description

Hydraulic and pneumatic fittings punish a guess. Too little torque leaks, and too much cracks a flare. The Snap-on TECH2Y100 torque wrench gives line and maintenance teams an electronic handle for 5 to 100 ft-lb. Its Y-shank receiver accepts open-end, flare-nut and ratchet heads, so one tool reaches many fittings.

Which shank does what

This handle is a Y model. Therefore only Y heads lock into it, and a standard Y head puts the fastener 3.00 inches beyond the retaining pin. Larger shanks belong to heavier handles, while J suits the lightest work.

Snap-on TECH2Y100 torque wrench in numbers

• Range: 5-100 ft-lb, 60-1,200 in-lb, or 6.8-135 N·m.
• Accuracy: ±4% clockwise and ±6% counterclockwise from 20% to 100% of full scale.
• Handle length: 15-1/2 inches, not counting the head.
• Working temperature: 40-110 °F (5-42 °C).
• Case: PBTECH2.

Also note the readout options. You can preset a target, track torque live, or hold the peak after a pull.

Heads come separately

Snap-on sells each head under its own part number. As a result, most buyers start with two or three heads and add more later. A flare-nut head suits brake and fuel lines, whereas a ratchet head speeds up runs of small bolts. In addition, SMK Vietnam already lists Y-shank click bodies, so ask Lost in HCM whether your existing heads can move between them.

Snap-on TECH2Y100 torque wrench or ControlTech Link?

Snap-on’s ControlTech Link CTLNK2Y100 shares the Y shank and the 5-100 ft-lb span. However, it adds a time-stamped data trail and a wireless link to a plant controller. So if you only need a correct reading, the Techwrench is the simpler buy. If your customer audits each joint, compare both models in one quote.

Daily care

First, wipe hydraulic fluid off the head after each job. Then store the handle in its case with the heads beside it. Finally, send it to your calibration lab on a fixed cycle.

Order through Lost in HCM

Lost in HCM supplies the TECH2Y100, and SMK Vietnam lists it as a partner product. When you request a quote from Lost in HCM, include the heads you want. For other handles and bodies, browse the torque wrench category. Not sure about fit? Contact SMK Vietnam first.

Questions about the TECH2Y100

Can it take X-shank heads?

No. The receiver only fits Y heads with a 0.560 inch shank.

What is 100 ft-lb in N·m?

About 135 N·m, which matches the figure in Snap-on’s catalog.

Is it a click wrench?

No. It is an electronic Techwrench that gives a tone and a vibrating handle at the preset.