Snap-on TE25FFUAC Torque Wrench, Torqometer U.S. Follow-up Dial, 3/8″ Drive, 25 ft-lb, with Chart

Description

Machine shops in Binh Duong, Dong Nai and Bac Ninh run CNC machining centers and lathes around the clock. A crash, a spindle swap or a turret repair can stop a cell for days. The Snap-on TE25FFUAC torque wrench helps machine tool technicians put the cell back together to spec. Its dial reads to 25 ft-lb, and a second needle keeps the peak.

CNC service tasks for the Snap-on TE25FFUAC torque wrench

After a collision, a technician often refits turret tool blocks, way covers and servo motor mounts. For example, the turret clamp screws must pull evenly, or the tool block may shift under cut. Coolant manifolds and probe brackets also need a steady value. With the TE25FFUAC, the peak stays on the dial, so the tech can read it after letting go.

The TE25FFUA catalog row

Snap-on prints these values in the US Reading/Standard 2% Accuracy table of catalog CAT1500i. According to that catalog, a C suffix orders the certificate of calibration model. So the TE25FFUAC is the C form of the TE25FFUA, and Lost in HCM’s title says with Chart.

Fine steps for machine tool work

Each mark on this dial equals 1/2 ft-lb, or 6 in-lb. That resolution helps when a manual gives a tight window for a turret or cover screw. In addition, the short 9-29/32 inch body fits inside a crowded machine enclosure. The TE25FFUAC also has basic and light signal siblings, the TE25FA and TE25FLA, in the same row.

The 2% band on the Snap-on TE25FFUAC torque wrench

Lost in HCM files this wrench under US Reading/Standard 2% Accuracy. Snap-on sets that grade at 2% of reading from 20% of full scale to full scale. On a 25 ft-lb dial, the band therefore starts at 5 ft-lb. For heavier spindle or chuck bolts, the TE50FFUA reaches 50 ft-lb.

Coolant, chips and storage

Coolant mist and fine chips settle on every surface in a machining cell. So wipe the Snap-on TE25FFUAC torque wrench before and after each job, and keep it in its PB9 case. Also reset the follow-up needle before each screw. Never use it to break a seized bolt loose, and send it for periodic recalibration.

Quote the TE25FFUAC through Lost in HCM

Lost in HCM supplies this wrench and prepares every quote. For a machine shop or a machine tool service firm, request a quote from Lost in HCM. You can also browse more torque wrenches on SMK Vietnam, visit snapon.com, or contact SMK Vietnam.

Machine tool service FAQ

Can the TE25FFUAC tighten retention knobs?

Only if the toolholder maker gives a torque in its range. Many shops use a dedicated fixture for that job, so check the holder maker’s method first.

Does the TE25FFUAC read N·m?

No, its dial reads ft-lb. Multiply by about 1.356, so the 25 ft-lb top end equals roughly 34 N·m.

What is the chart in the TE25FFUAC title?

Lost in HCM says with Chart but does not describe it. Per the catalog, the trailing C orders the certificate version, so confirm the papers before you order.