Snap-on CTECHANM30 Torque Wrench, ControlTech Micro Digital, IZO/ISO 9 x 12 mm Interchangeable Head, 1.5-30 N·m

Description

Metric fittings on European machines and aircraft often need low torque in cramped spots. The Snap-on CTECHANM30 torque wrench suits that mix. It is a ControlTech Micro digital wrench with a 9 x 12 mm IZO/ISO head fitting. It covers 1.5 to 30 N·m, or about 1.11 to 22.13 ft-lb.

What Micro Size means on the CTECHANM30

Snap-on describes the Micro line as fully featured electronic wrenches in a smaller form. The body is shorter than a standard ControlTech, which gives a finer feel on small fasteners. In addition, steel construction and a rugged gyroscope give strong drop protection.

IZO/ISO heads on the Snap-on CTECHANM30 torque wrench

Unlike the J, Y, X and Z shank models, this wrench takes a rectangular 9 x 12 mm end fitting. So you can fit a ratchet, open-end, ring or flare-nut head made to that size. Heads come separately, and 14 x 18 mm heads will not fit. The full-size CTECHAN30A and CTECHAN135A use the same 9 x 12 mm size, so one head set can serve all three.

CTECHANM30 features for audits and clean areas

• A FOD-proof cover slides open to reveal the USB port.
• A real-time clock flags when calibration is due.
• You can set torque and angle presets, then build jobs from them.
• It stores up to 1,500 readings.

The FOD cover helps in aircraft hangars, where loose debris is a hazard. Also, the clock alert helps a QA team keep out-of-date tools off the line.

Accuracy and units

The catalog rates torque at ±2% clockwise and ±3% counterclockwise, with angle from 0 to 360°. Because the scale is metric, set targets in N·m rather than convert them.

Quote for the Snap-on CTECHANM30 torque wrench

Lost in HCM supplies this Micro wrench, and SMK Vietnam lists it for them. Note the 9 x 12 mm heads you need, then request a quote from Lost in HCM. Other torque wrenches sit in the same category, or you can contact SMK Vietnam.

CTECHANM30 FAQ

Will my CTECHAN30A heads fit?

Both wrenches use the 9 x 12 mm size, so the heads match. Still, check each head’s rating with Lost in HCM.

How does it differ from the CTECHAN30A?

Both reach 30 N·m with 9 x 12 mm heads. The CTECHANM30, however, uses the shorter Micro body.

Can it read angle?

Yes. The Micro line reads angle from 0 to 360°, so it handles torque-plus-turn specs.