Rohde & Schwarz RT-ZC10 Probe, 10 MHz Current Clamp with BNC Output, 150 A RMS

Description

The Rohde & Schwarz RT-ZC10 probe is a clamp-type current probe with 10 MHz bandwidth and a BNC signal output. Unlike its B-suffix sibling, it takes power from a separate supply rather than from the oscilloscope. That detail shapes how you plan a measurement, so this page covers it first.

How the RT-ZC10 connects

Rohde & Schwarz lists the RT-ZC10 with a BNC output that requires the R&S RT-ZA13 external power supply. In practice, you run two links: the signal cable to a scope channel and the power lead to the supply. So when you request a quote, ask whether the RT-ZA13 belongs in the package or needs its own line. The probe and supply carry separate order numbers.

Numbers that matter

Jobs suited to the Rohde & Schwarz RT-ZC10 probe

A 150 A clamp with 10 MHz of bandwidth covers a lot of factory power work. For instance, maintenance teams can trace compressor or pump drive currents during a fault hunt. Meanwhile, R&D groups can check the input current of a switch-mode supply, or the charge current into a battery pack. Test engineers also use a clamp like this to compare current profiles between a good unit and a returned one.

RT-ZC10 versus RT-ZC10B

Both share the 10 MHz and 150 A figures on the manufacturer page. However, the RT-ZC10B uses the Rohde & Schwarz probe interface, while this model works through BNC plus the external supply. Therefore, pick based on the scope inputs and supplies your lab already has.

Compatibility check

Lost in HCM catalogs the RT-ZC10 as an option for the R&S RTM3000 family. Even so, confirm your oscilloscope model, firmware and input setup before you order. After that, Lost in HCM can quote a short rental for a project or an outright purchase.

Ordering and support

To start, request a quote from Lost in HCM and include your scope model and dates. You can also compare other oscilloscope probes or contact SMK Vietnam. Rohde & Schwarz publishes the data on its current probe overview. As always, follow the manufacturer’s manual and ratings when you use the Rohde & Schwarz RT-ZC10 probe.

Questions about the RT-ZC10

Why does this probe need a separate supply?

Its output runs over BNC rather than the probe interface, so the RT-ZA13 supply powers the clamp electronics instead.

Can Lost in HCM supply the RT-ZA13 as well?

Ask in your quote request. Lost in HCM confirms what it can supply for each order.

Which order number should the quote show?

The manufacturer order number for the RT-ZC10 is 1409.7750K02.