Snap-on VERSA600LDR2 torque loader, Versatest mechanical loader for torque wrench testing

Snap-on VERSA600LDR2 Torque Loader, Versatest Mechanical Loader for Wrenches up to 600 ft-lb

Name: Snap-on VERSA600LDR2 Torque Loader, Versatest Mechanical Loader for Wrenches up to 600 ft-lb
Brand: Snap-on
SKU: LIH-VERSA600LDR2
Availability: InStock

The Snap-on VERSA600LDR2 torque loader is the mechanical half of a Versatest bench. It loads dial, micrometer, beam and electronic wrenches up to 600 ft-lb against a TTC transducer. Lost in HCM supplies it.

SKU: LIH-VERSA600LDR2

Category: Torque Testers & Calibration Systems

Brands: Snap-on

Description

A Versatest indicator only reads what the bench feeds it. If technicians pull wrenches by hand, the speed and angle change on every test. The Snap-on VERSA600LDR2 torque loader takes that variation out. It holds the wrench and applies load through a crank, up to 600 ft-lb.

When to buy the loader on its own

Snap-on sells the VERSA600LDR2 inside the VERSATEST600 system. Even so, a separate loader makes sense in a few cases:

You already run a Versatest indicator and transducers, but test by hand today.
You want a second loading station beside an existing bench.
An older loader needs replacing, while the electronics still serve well.

What the Snap-on VERSA600LDR2 torque loader handles

Snap-on’s catalog says the unit loads dial, micrometer, beam and electronic torque wrenches. Its maximum capacity is 600 ft-lb. It also accepts any TTC series transducer from 15 in-oz to 600 ft-lb. For example, the TTC12 3/4 in transducer, rated 60 to 600 ft-lb, covers the loader’s top end.

Notes for the TTC400 and screwdrivers

The TTC400 4-in-1 transducer needs the TTC5000-1 adaptor plate on this loader. In addition, Snap-on lists a TTC75006 torque screwdriver testing kit for the VERSATEST600 loader system. So the same station can cover small drivers as well as large wrenches.

Rules Snap-on prints for the VERSA600LDR2

Do not exceed the rated torque.
Do not use it to break fasteners loose.
Plan periodic recalibration to hold accuracy.

Therefore, keep heavy wrenches above 600 ft-lb on a larger bench such as a TTC2000 system.

Setting it on the bench

Snap-on’s older UK brochure describes the earlier VERSA600LDR as a portable table-top loader with a safety shield. Treat the Snap-on VERSA600LDR2 torque loader the same way: place it on a firm, clean surface at a comfortable height. Then route the transducer cable clear of the crank. Also keep the shield in place for every test.

Getting a quote

SMK Vietnam lists the Snap-on VERSA600LDR2 torque loader for Lost in HCM, which supplies it and prepares quotes. Mention the indicator and transducers you own when you request a quote from Lost in HCM. Browse more torque testers and calibration systems on our site, read about the brand at snapon.com, or contact SMK Vietnam.