Description
The Snap-on TTC65 torque transducer reads 15 to 150 in-lb on a 1/4 in square drive. That band, about 1.7 to 17 N·m, covers many small click wrenches and preset bodies on assembly lines. It also reaches three times higher than the TTC6, so it takes over where that low-range sensor runs out.
Wrenches to test on the Snap-on TTC65 torque transducer
Take the QC1P100 preset J body, which sets anywhere from 15 to 100 in-lb. So its whole span fits inside the TTC65 range. The QC1I200 adjustable runs 40-200 in-lb, so test points at 20, 60 and 100% fall at 40, 120 and 200 in-lb. The first two suit the TTC65. However, the top point needs the 3/8 in TTC7, which reads 30-400 in-lb. On the other hand, a QC1P60 set below 15 in-lb belongs on the TTC6.
Mount, adaptor and calibration wheel
CAT1500i pairs the Snap-on TTC65 torque transducer with the TTC3421 bench top mount. In fact, that mount holds sensors from the 5-50 in-oz unit up to the 80-1,000 in-lb unit. According to the catalog, every TTC transducer also includes the correct adaptor for its range. For checks on the sensor itself, the TTC1510 5 in calibration wheel tops out at 150 in-lb, the same as the TTC65 full scale.
Monitors and power tools on the TTC65
The TTC65 connects to the Versatest monitor and to TTC2000 or TTC2800 systems. Each transducer carries a memory chip that identifies it, so the monitor knows the range at once. Snap-on quotes these systems at ±0.25% of indicated value from 10 to 100% of full scale. For nonimpacting power screwdrivers, the QC1JRS50 joint rate adaptor sits on a 1/4 in tester drive and holds up to 50 in-lb. In addition, its stacked washers can simulate a soft, medium or hard joint.
Protecting the TTC65 sensor
Never load the sensor past 150 in-lb, because Snap-on warns against exceeding rated torque. Also keep the square drive clean, and store the unit in its case between sessions. Snap-on adds that periodic recalibration checks keep tester accuracy, so book the TTC65 into your own calibration plan.
Request a Snap-on TTC65 torque transducer quote
SMK Vietnam lists the Snap-on TTC65 torque transducer, while Lost in HCM supplies it and issues the price. First, tell them your monitor or system and the smallest wrenches you test. With those details, request a quote from Lost in HCM for the TTC65. Related parts sit in torque testers and calibration systems, and you can contact SMK Vietnam as well.
TTC65 range and setup FAQ
How does the TTC65 range convert to N·m?
It works out to about 1.7 to 17 N·m, from Snap-on’s printed 15-150 in-lb.
Can the TTC65 check a 200 in-lb setting?
No. That point sits above its full scale, so use the 3/8 in TTC7 instead.
Which kit adds torque screwdriver testing?
For TTC2000 and TTC2800 systems, Snap-on lists the TTC75002 kit. For the VERSATEST600 loader, it lists the TTC75006. Both work alongside sensors such as the TTC65.
Reviews
There are no reviews yet.