Description
Wire harness and connector plants live on pull tests. A crimp that holds too little fails in the field, so the pull gauge itself has to be right. The Snap-on TTC2610 tension gauge kit gives a TTC bench the fixtures to load those gauges in tension. Your lab can then check them on the same indicator it uses for torque.
What the Snap-on TTC2610 tension gauge kit adds
Snap-on lists the TTC2610 under its force testing equipment. The catalog explains that the TTC600 and TTC800 loaders can deliver tension loads with TTC series transducers. Meanwhile, the TTC610 and TTC810 indicators measure, store and analyze force readings. So this kit is the missing link between a torque bench and a hook-style pull gauge.
Parts that work alongside it
| Item | Why you need it |
|---|---|
| TTC600 or TTC800 loader | Applies the pull |
| TTC610 or TTC810 indicator | Reads and logs the reference force |
| TTC26302 force arm kit | Shared arm hardware for force testing |
| Single TTC transducer | Reference sensor; the TTC400 4-in-1 cannot do force work |
Pull-gauge jobs the TTC2610 supports
- Crimp pull-off checks on harness lines.
- Connector retention and latch tests in electronics assembly.
- Peel and tape tests in packaging and labeling.
- Spring and return-force checks in mechanism assembly.
In each case, the gauge sets pass or fail for a product. Therefore, a drifting gauge can pass bad parts or scrap good ones.
Running a TTC2610 tension check well
Hang the gauge in a straight line with the load path, because a side angle reads low. Then pull at an even rate and compare readings at a few points on the scale, such as low, middle and high. Also keep the room steady, since Snap-on lists a 10 to 32 °C operating range for the TTC2000 system. Finally, log each result in the indicator, which stores up to 3,000 readings.
Get the TTC2610 through Lost in HCM
SMK Vietnam lists the Snap-on TTC2610 tension gauge kit for its partner Lost in HCM, which supplies it and gives quotes. Include your gauge ranges and bench model when you request a quote from Lost in HCM. You can also check other torque testers and calibration systems, visit snapon.com, or contact SMK Vietnam.
Snap-on TTC2610 tension gauge kit FAQ
What else do I need besides the TTC2610?
Plan for a TTC600 or TTC800 loader, a TTC610 or TTC810 indicator, the TTC26302 force arm kit and a single TTC transducer.
Does the kit check cable tensiometers?
Snap-on lists a separate TTC2600 kit for tensiometers. The TTC2610 targets tension gauges.
Which force units can I read?
Snap-on lists lbf, ozf, N, dN, kp and gf for the TTC indicator.
Reviews
There are no reviews yet.