Description
A paper machine runs wet, hot and loud, often around the clock. During a shutdown, crews rebuild dryer bearings, press roll mounts and pulper drives held by large bolts. The Snap-on TEX2003TL torque wrench gives those crews a light that marks the target on a dial. It is a U.S.-reading Torqometer T-handle head, and Lost in HCM tags it for hydroelectricity too.
Shutdown work with the Snap-on TEX2003TL torque wrench
Mill shutdowns run on tight schedules, so every hour of bolting counts. The machine builder sets values for bearing housings, gearbox feet and roll stand bolts. With this head, the fitter pulls until the lamp flashes, then stops. Next, the dial shows the value for the record. Because steam and fog cut sight lines, a bright cue helps more than a fine needle.
TEX2003TL row in Snap-on’s tables
| Feature | TEX2003TL |
|---|---|
| Input drive | 1 in female square |
| Output drive | 1 in male square |
| U.S. range | 2,000 ft-lb |
| Length / width / head depth | 10-7/8 in / 4-3/8 in / 4-7/16 in |
| Indicator | Signal light that flashes at the target |
| Optional handles | 82TQP T bar and 85TQP extension handle |
These values come from the U.S. T-handle table of Snap-on catalog CAT1500i. In addition, a 2005 Snap-on notice on reinstated Torqometers shows the TEX2003TL at 2,000 ft-lb with 1-inch drives. Per the catalog, these heads ship without a certificate unless a C ends the stock number.
How the TEX2003TL signal light helps
On a signal model, Snap-on fits a lamp in the head that flashes once the bolt reaches the target. So the fitter can watch the bolt and the lamp instead of a small mark. In practice, that cuts misreads at the end of a long night shift. Still, read the dial after each pull to confirm the value.
Sizing the TEX2003TL for mill joints
Snap-on guarantees 2% of reading over the upper 80% of the scale. On this head, the guaranteed band begins at 400 ft-lb. Therefore the Snap-on TEX2003TL torque wrench suits values from there to 2,000 ft-lb, roughly 2,710 N·m. For smaller bearing caps, a 600 or 1,000 ft-lb head reads finer. Also, never use it to break seized bolts loose.
Quote for the Snap-on TEX2003TL torque wrench
Pricing and supply for this head run through Lost in HCM. Before your next mill stop, request a quote from Lost in HCM. You can also compare other torque wrenches on SMK Vietnam, read more at snapon.com, or contact SMK Vietnam.
TEX2003TL paper mill FAQ
How do I set the target for the TEX2003TL light?
The sources do not describe the setting method. Ask Lost in HCM for the Snap-on instructions before the first job.
What are the dial steps on the TEX2003TL?
Snap-on’s two sources print this row out of order, so this page does not state the step. Confirm it in your quote.
Does a damp mill harm the head?
Moisture can corrode any tool. Dry the TEX2003TL after each shift and keep it in a dry store between shutdowns.
Reviews
There are no reviews yet.