Snap-on TER602LAC Torque Wrench, US/N·m Light Signal Torqometer, 3/4″ Drive, 800 N·m, with Calibration Certificate

Description

Truck and bus fleets lose time and money when a wheel or spring joint works loose on the road. The Snap-on TER602LAC torque wrench gives a fleet workshop a precise way to set and check those heavy joints. It reads in US units and newton meters, while a lamp flashes at the target. According to the source name, it includes a calibration certificate.

Signal cues for the Snap-on TER602LAC torque wrench

Fleet bays are loud with air tools and engines. In addition, a mechanic in a pit often pulls from an awkward stance. So a flash at the set point tells the mechanic to stop, even when the dial sits out of view. The needle then shows the actual value for the job card.

Catalog figures for the TER602LA

Snap-on’s Precise 1% US/newton meter chart gives these values. Its note on the same page says a C suffix orders the certificate version, so the TER602LAC is that variant.

Fleet jobs for the TER602LAC

• Wheel nut checks after a tire change, before the truck leaves the yard.
• Spring U-bolt nuts after a leaf spring or axle repair.
• Fifth wheel mounting bolts on tractor units.
• Suspension hanger and torque rod bolts on buses.

Always take the value from the vehicle maker, because specs vary by model. Then make sure it sits inside the dial.

Precision grade and the working band

Lost in HCM places the TER602LAC in its Combination US/Newton Meter Reading/Precise 1% Accuracy group. Snap-on defines that grade as within 1% of reading from 20% of full scale upward. Here, the band begins at 160 N·m or 120 ft-lb. So lighter brake and cab bolts suit a smaller wrench.

Looking after the Snap-on TER602LAC torque wrench

A long wrench can bend if someone uses it as a pry bar. So keep it in its case on the tool board. Also test the lamp at the start of each shift, and confirm the needle rests at zero. Then recalibrate it on the interval your fleet program sets.

Request the TER602LAC from Lost in HCM

Fleet managers can source the Snap-on TER602LAC torque wrench from Lost in HCM, our partner for this listing. For fleet pricing, request a quote from Lost in HCM. You can also browse more torque wrenches, read about Snap-on at snapon.com, or contact SMK Vietnam for help with sizing.

Fleet workshop FAQ for the TER602LAC

Can the TER602LAC check wheel nuts?

It can if the truck maker’s figure sits inside the dial. Snap-on lists the base TER602LA at 800 N·m and 600 ft-lb.

Should I use it with an impact socket?

Use a hand socket in good condition. Never run the wrench on an impact tool or use it to loosen nuts.

Is a certificate included?

The listing name says so. For the certificate details, check with Lost in HCM before the order.