Description
Solar farms in Ninh Thuan and Binh Thuan pass from builder to owner with thick quality files. The Snap-on TE250C Torqometer fits that hand-off, since Lost in HCM lists it as “U.S. Basic (with Chart)”. If paperwork does not matter to you, compare it with the plain TE250 dial wrench, which shares every catalog figure.
Same TE250 frame, extra documents
Snap-on’s CAT1500i catalog prints a single TE250 row. Its table note says the C suffix marks certificate of calibration models, while the listed codes ship without one. Hence the TE250C buys a document, not a new dial. Because the listing does not describe the chart, ask Lost in HCM for a sample page.
Who asks for the record?
| Party | Typical need | Code |
|---|---|---|
| Owner’s engineer at handover | Tool status in the QA file | TE250C |
| EPC site QA | Document before first use | TE250C |
| O&M team with a torque tester | In-house verification | TE250 |
| Spare kit for a second site | Cross-check against a master | TE250 |
Solar field joints for the Snap-on TE250C Torqometer
Tracker drive mounts, torque tube clamps and inverter skid anchors often carry values in this band. So an O&M crew can audit them on a planned walk with the TE250C. Even so, take every value from the tracker or skid maker. Lighter module clamps sit low on this scale, so use a smaller frame for those.
TE250C data in short
The catalog gives a 1/2 inch drive, a 250 ft-lb range in 5 ft-lb steps and a 23-3/4 inch length. Width measures 2-3/4 inches and head depth 1-3/8 inches, with a PB8A case. Snap-on’s UK brochure rates Torqometer readings within 2% from 20% of full scale. Thus the TE250C band runs from 50 to 250 ft-lb, or about 68 to 339 N·m.
Sun, dust and storage
Snap-on rates this line for 0 to 100 °F, which equals about -18 to 38 °C. So never leave the Snap-on TE250C Torqometer in a hot truck cab at noon. Also return it to its PB8A case after each block, because red dust works into every gap. Never use it to break a rusted bolt loose.
Lost in HCM pricing for the Snap-on TE250C Torqometer
Lost in HCM supplies this wrench in Vietnam and prepares each quote for SMK Vietnam buyers. Put the TE250C code on your request, then request a quote from Lost in HCM. You can also view the rest of our torque wrenches, visit snapon.com, or contact SMK Vietnam.
Solar O&M FAQ
Does the TE250C come with a peak needle?
No. It sits in the Basic column with one needle, while the TE250FU adds a follow-up needle.
Can we convert readings to N·m on site?
Yes. Multiply ft-lb by about 1.356. For example, 200 ft-lb comes to about 271 N·m.
Reviews
There are no reviews yet.