Description
Small torque wrenches and drivers need a small sensor, or the reading gets lost in the noise. The Snap-on TBTT16A torque transducer covers the bottom of Snap-on’s horizontal bench tester range. It reads from 7.5 to 200 in-lb, so it suits the light tools that assembly lines use most.
Where the TBTT16A fits in the TBT system
Snap-on sells the TBT600A as a horizontal torque tester that includes three transducers. The system has a full digital display, peak hold and first peak hold, and Snap-on describes it as NIST traceable. Within that set, the TBTT16A takes the low end, while the TBTT600A handles 30-600 ft-lb. The TBTT100A sits between the two.
TBTT16A data
| Range | 7.5-200 in-lb (about 0.85-22.6 N·m) |
|---|---|
| Resolution (examples) | 0.002 ft-lb; 0.002 N·m |
| Display units on the system | ft-lb, in-lb, in-oz, N·m, kg-m, kg-cm |
Is the Snap-on TBTT16A torque transducer right for your tools?
Compare the range with the wrenches on your check list. For example, Snap-on’s QC1I200 body covers 40-200 in-lb, and its QDRIVER4A torque driver covers 5-40 in-lb. Snap-on states its QC bodies’ accuracy from 20% to full scale. So the QC1I200 test band of 40-200 in-lb sits inside the transducer range. A driver set below 7.5 in-lb, however, falls under it.
Why buy a single transducer
Labs usually order one to replace a damaged sensor, or to keep a spare while another is out for calibration. That way, the bench stays in service. Ask Lost in HCM to confirm the match with your display before you order.
Handling the TBTT16A
Never load the Snap-on TBTT16A torque transducer past 200 in-lb, because Snap-on warns against exceeding rated torque. Also guard the cable and connector from crushing and sharp bends. Then store the sensor clean and dry, and keep it on a regular calibration cycle with your usual provider.
Quote for the Snap-on TBTT16A torque transducer
Lost in HCM supplies the TBTT16A and prepares the quote. SMK Vietnam lists it and does not stock or calibrate it. Mention your tester model and serial number in the request. After that, request a TBTT16A quote from Lost in HCM. For the wider bench range, see torque testers and calibration systems, or contact SMK Vietnam.
TBTT16A FAQ
What range does the TBTT16A cover?
Snap-on lists 7.5-200 in-lb, which is about 0.85-22.6 N·m.
Is it the only transducer in the TBT system?
No. Snap-on says the horizontal tester includes three transducers. The TBTT600A, for example, covers 30-600 ft-lb.
Does SMK Vietnam calibrate the transducer?
No. SMK Vietnam lists the part for Lost in HCM. Use your usual calibration provider for checks.
Reviews
There are no reviews yet.