Snap-on IZ32OE14X18 Torque Insert, 32 mm Open End for 14 x 18 mm Receivers

Description

A 32 mm tube nut on a hydraulic line cannot take a ring, because the pipe runs right through it. The Snap-on IZ32OE14X18 torque insert answers that with a 32 mm open end on a 14 x 18 mm IZO/ISO fitting. It slides onto the flats from the side. So a heavy electronic body can torque the nut without opening the line.

Jobs for a 32 mm open jaw

Large hydraulic unions and pump fittings often carry 32 mm flats. In addition, DIN 934 gives M22 nuts a 32 mm hex, while ISO 4032 moves M22 up to 34 mm. Check which standard your drawing follows before you order. In each case, the open end of the IZ32OE14X18 reaches nuts that a closed ring cannot pass over.

Only the 14 x 18 fitting reaches 32 mm

Snap-on’s 9 x 12 open ends stop at 19 mm, so the 32 mm IZ32OE14X18 exists only for the larger fitting. In CAT1500i, the IZ30OE14X18 sits one step below. Above it, the IZ36OE14X18 closes the range. The closed twin, the IZ32IR14X18, covers the same hex wherever you can reach it from above.

Body range for the Snap-on IZ32OE14X18 torque insert

CAT1500i prints no torque rating for IZO inserts, so the body sets the ceiling. Snap-on also calibrates from 20 to 100% of full scale. Check your spec against both ends, then. Under 68 N·m the reading leaves the calibrated band, while over 340 N·m the body simply runs out of scale.

Pulling safely with the Snap-on IZ32OE14X18 torque insert

An open end touches two flats, so it spreads load less evenly than a ring. Therefore seat the jaw fully, square to the nut, and pull slowly at the grip. Before each job, also choose the stored head-length factor on the ControlTech body. Never use the Snap-on IZ32OE14X18 torque insert to break a nut loose, which Snap-on warns against for every insert.

Pricing the 32 mm IZ32OE14X18 insert

SMK Vietnam lists this insert as a partner part, and Lost in HCM supplies the IZ32OE14X18 and prices it. Mention your body model and the joint value in the request. With that, place an IZ32OE14X18 quote request with Lost in HCM. The 30 mm and 36 mm steps appear among our torque wrench heads and adaptors, and you may also contact SMK Vietnam.

IZ32OE14X18 points to check

Which bolt size uses a 32 mm nut?

DIN 934 M22. ISO 4032 gives M22 a 34 mm hex instead, so measure the flats before you order.

Can a 9 x 12 body take the IZ32OE14X18?

No. Snap-on makes its 32 mm inserts for the 14 x 18 fitting only.

Should I pick the ring or the open end at 32 mm?

Pick the IZ32IR14X18 ring when the nut is open from above. Pick the IZ32OE14X18 when a pipe or stud blocks the ring.