Keysight N8925A DC Power Supply, 80 V, 340 A, 10000 W, N8900 Series

Description

Before a 10 kW supply arrives, walk the room first. The Keysight N8925A DC power supply is an N8900 Series autoranging unit rated 80 V, 340 A and 10000 W, so the site matters as much as the bench. It takes 208 VAC three phase. Lost in HCM lists it for rental, repair and sale in Vietnam.

Site readiness for the Keysight N8925A DC power supply

Start with facility power, because the unit needs a three-phase feed that suits its input. Then check grounding and ventilation around the rack. In addition, confirm the rack space, the network connection and the safety controls. Finally, plan how you will reach the output terminals with heavy cable.

Ask Lost in HCM for a photo of the label and the option list. The factory input option must match your installation, so do not guess from the front panel. Similar panels can hide important configuration differences.

Ratings at a glance

What 340 A means at the bench

The full 340 A is a low-voltage figure, because the 10000 W limit caps the product of voltage and current. It holds only up to about 29 V. At the full 80 V, the ceiling drops to 125 A. However, even 125 A is a large load for any cable.

Therefore, ask an engineer to review conductor rating and connection resistance before you power a load. Then set the overvoltage and current limits from the device under test.

Typical work and ownership options

Manufacturers use a source of this size for burn-in, endurance testing and production screening of DC-powered assemblies. Labs also use it for converter inputs and controlled load tests. However, it is a DC source only, so it does not replace a regenerative supply.

Rent the Keysight N8925A DC power supply for a production ramp or a short project, or ask about a purchase instead. If your own unit fails, Lost in HCM starts repair intake from the serial number and photographs. Then request a quote from Lost in HCM. You can also see more power supplies, visit Keysight, or ask SMK Vietnam. Meanwhile, SMK itself does not stock or service the unit.

N8925A questions

What should I check in the room?

Check facility power, grounding, ventilation, rack space, network and safety controls. Also match the AC-input option to your site.

What can I expect at the full 80 V?

Around 125 A, since 10000 W divided by 80 V sets the ceiling. So the full 340 A needs a lower voltage, below roughly 29 V.

Is the front panel in the photo my unit?

Not exactly. It is a family image, so the quote confirms the model and the options.