Description
A supply that also reports what it delivers earns its place on a test station. The Keysight N6764A DC power module is a precision, autoranging module rated to 60 V and 20 A within 300 W. It uses two slots in an N6700 or N6705 frame. Lost in HCM lists it for rental and sale.
Ratings in one table
| Outputs | 1 |
|---|---|
| Maximum voltage | 60 V |
| Maximum current | 20 A |
| Maximum power | 300 W |
| Architecture | Autoranging, precision |
| Module width | Double slot |
| Output response time | 0.1 ms |
| Sensing | Four-wire remote sense |
What the precision label means for you
The listing calls this a precision module. It gives ratings, not accuracy figures, so ask for the data sheet values for programming and readback before you commit. Those numbers matter most when a test compares small changes in voltage or current from one run to the next.
Staying inside 300 W
The two headline limits multiply to 1,200 W, which is four times the rating, so the output cannot hold both. At 60 V the module supports 5 A. At 20 A it supports up to 15 V. Therefore plan each test point against 300 W, not against two separate limits.
Where the Keysight N6764A DC power module sits in a test cell
Fixtures and long runs reward a source you can program and log. LIST mode, the data logger and arbitrary waveforms support dynamic, automated tests. In addition, four-wire remote sense compensates for voltage lost in the load leads.
- Supplying device-under-test rails and ATE fixture resources.
- Developing embedded, automotive and industrial electronics.
- Verifying multi-rail power sequencing before shipment.
Frame and lead checklist
The module needs a compatible N6700 or N6705 mainframe. Check the firmware, the free slots and the total power of every module in the frame. Then list the load leads, the sense leads and the connector block. As a result, the quote can show a complete package and not just a module.
Request it through Lost in HCM
SMK Vietnam shows the listing, and Lost in HCM supplies the module. Rental fits a project with a clear end date, while a purchase fits a station that runs daily. To order the Keysight N6764A DC power module, request a quote from Lost in HCM with your voltage, current, frame and dates. You can also browse power supplies, visit the Keysight website or contact SMK Vietnam.
N6764A questions
Does this page list accuracy figures?
No. It lists ratings only, so ask Lost in HCM for the Keysight data sheet if your test needs programming or readback figures.
What current can I draw at 60 V?
Up to 5 A, because the 300 W limit applies to the whole output.
Which mainframes take the N6764A?
Compatible Keysight N6700 low-profile modular power systems and N6705 DC power analyzers, after you confirm firmware, slots and power.
Reviews
There are no reviews yet.