Description
Some loads want volts more than amps, so voltage rating comes first. The Keysight N6735B DC power module suits them, with a single output of up to 60 V and 0.8 A inside a 50 W, one-slot package. Lost in HCM also lists it for rental and sale, and it arranges service on request.
Rating table
| Outputs | 1 |
|---|---|
| Maximum voltage | 60 V |
| Maximum current | 0.8 A |
| Maximum power | 50 W |
| Module width | Single slot |
| Platforms | N6700 modular power systems and N6705 DC power analyzers |
| Sensing | Four-wire remote sense |
Reading the 60 V and 0.8 A rating
The module tops out at 60 V and at 0.8 A. So check your worst-case load against both limits, not just the power figure. However, if a rail needs more current at a lower voltage, the sister N6734B, rated 35 V and 1.5 A, may fit better. Lost in HCM lists both modules, so you can compare them side by side.
Speed and control
An output response time of 0.2 ms keeps the supply quick, because loads change fast. Commands take about 32 ms to process, so plan scripts around that pace. In addition, you can set the slew rate, run LIST mode, log data and generate arbitrary waveforms. As a result, these functions turn a plain supply into a programmable stimulus for dynamic tests.
Sizing a rental around the Keysight N6735B DC power module
Work through these questions before you send a request:
- Which mainframe will host the module, and which firmware does it run?
- How many outputs must run at once, because the total power then sets the budget?
- Do you also need the output-disconnect relay option?
- Which load and sense leads, plus which connector block and interface, will you use?
- Which automation software will then drive the unit?
Rental and used offers can vary by serial number. So a clear answer to each question helps Lost in HCM compare equal configurations.
Where a higher-voltage module helps
For example, embedded, automotive and industrial boards often mix low-voltage logic with higher-voltage rails. This module can feed those higher rails while other slots in the mainframe serve the logic. It also powers ATE fixture resources and supports production verification, for example when a line checks several boards in sequence.
How to order
Lost in HCM holds the equipment, while SMK Vietnam only shows the listing. To order the Keysight N6735B DC power module, ask Lost in HCM for a rental or purchase quote and state your mainframe, quantity and dates. You can also read the power supply listings or the maker’s pages on the Keysight website. Also, contact SMK Vietnam for help with the request.
N6735B questions
What is the voltage and current rating?
The N6735B reaches 60 V and 0.8 A on its one output, while maximum power is 50 W.
Does it work in an N6705 analyzer?
It is compatible with N6700 modular power systems and N6705 DC power analyzers. Then verify the firmware and slot with Lost in HCM.
Is service available?
Lost in HCM also arranges service on request, so mention your serial number if you already own a module.
Reviews
There are no reviews yet.