Keysight E36232A Power Supply, Single Output, Autoranging, 60 V, 10 A, 200 W

Description

Some loads need more volts than amps. The Keysight E36232A power supply is a single-output autoranging bench source rated 60 V, 10 A and 200 W, so it leans toward higher voltage. Lost in HCM lists it for rental and sale in Vietnam.

Volts first, amps second

Multiply 60 V by 10 A and you reach 600 W, which is three times the unit’s rating. Therefore, the output cannot hold both maximums at once. It slides along the 200 W line instead.

• Up to 10 A at 20 V or lower.
• Near 5 A at 40 V.
• Near 3.3 A at 60 V.

These values follow from simple division. Check the official data sheet before you finalize a test plan.

Matching the Keysight E36232A power supply to a load

Start with the highest voltage your device needs, then check the current at that voltage. If the current fits under the line above, the Keysight E36232A power supply suits you. However, a motor or heater that draws a lot at 60 V may call for a bigger source.

Where higher voltage helps

Battery packs, converter stages and sensor circuits often sit above 30 V. Engineers also use such a source to feed device and module evaluation. Because the output is a single channel, it suits one high-voltage rail better than a multi-rail board.

Practical care for the Keysight E36232A power supply

Switch the output off before you move test leads. Besides that, keep the leads short and rated for the current you expect, and use remote sense when drops matter. In addition, let the unit warm up before you take precise readings.

Tell Lost in HCM the voltage and current of your device and how long you need the unit. Then request a quote from Lost in HCM. Related power supplies sit in the same category, and Keysight publishes the full data sheet. Contact SMK Vietnam if you need guidance.

Questions on the E36232A

Can it supply 60 V at 10 A?

No. That load would need 600 W, and the rating is 200 W. Near 60 V the current reaches about 3.3 A.

Is the E36232A a multi-output supply?

No. The listing describes a single-output autoranging unit.

When should I choose it over a 30 V model?

Pick it when the device needs a rail above 30 V. Choose a 30 V, 20 A unit when the load draws more current.