Keysight E36104B Power Supply, Single Output, 35 V, 1 A, 35 W, E36100B Series

Description

Factory control cabinets run on 24 V. The Keysight E36104B power supply tops out at 35 V and 1 A, which puts a 24 V rail comfortably inside its range. Lost in HCM lists this single-output benchtop source for rental and sale in Vietnam.

A 24 V bench for control hardware

Keysight rates the E36104B at 35 V, 1 A and 35 W, and the three numbers agree because 35 V times 1 A equals 35 W. That suits input modules, proximity sensors and small signal lamps. Moreover, a bench source lets you test each part before it goes into a cabinet. Then a wiring fault in the panel cannot damage an untested device.

Know the one-amp limit

One amp is a firm ceiling for this output. Solenoid valves, contactor coils and relay banks may ask for more, so read their data sheets first. If a load needs more current, choose a higher-current model instead of pushing this one. Meanwhile, a fuse close to the load protects both the supply and your wiring.

Using the Keysight E36104B power supply on the bench

1. Set the current limit to the load rating before you connect anything.
2. Switch the output off, then clip on the leads.
3. Raise the voltage in steps while you watch the display.
4. Use the sense terminals when long leads cause a visible drop.

Planning the loan

Plant engineers often rent for a commissioning window or a line change. A purchase suits a test station that needs the same rail every day. Share your dates, plug type and delivery city, then request a quote from Lost in HCM. You can also look at other power supplies here, or contact SMK Vietnam. The Keysight website lists the family documents.

E36104B questions

Can the Keysight E36104B power supply stand in for a cabinet supply during repair?

For small loads, yes. However, the 1 A limit means a full cabinet needs a larger source.

Does 35 W apply at every voltage?

No. The 35 W figure marks the corner where 35 V meets 1 A. At lower voltages the current stays capped at 1 A, so the power drawn is lower.

What should I send with my request?

Send the load voltage, the peak current, your dates and your delivery city. That lets Lost in HCM check the match before it quotes.