Keithley 2200-30-5 Power Supply, Single-Channel Programmable DC, 30 V, 5 A, 150 W

The Keithley 2200-30-5 power supply offers one programmable output up to 30 V, 5 A and 150 W, with USB and GPIB control. Lost in HCM lists it for rental and sale.

SKU: LIH-2200-30-5
Category:

Description

Many industrial controllers run from a 24 V rail, and they need a bench source with room to spare. The Keithley 2200-30-5 power supply gives you one programmable output up to 30 V and 5 A. Lost in HCM supplies it for rental or sale and can arrange service when you ask.

Keithley 2200-30-5 power supply, gray bench unit with a black display, numeric keypad, rotary knob and red, black and green output terminals

Headroom above a 24 V rail

A 30 V ceiling lets you test a 24 V device and still sweep the input a little high or low. That matters for brown-out and over-voltage checks. However, always confirm what your own circuit tolerates before you raise the setting. Then step the voltage up in small increments and watch the current reading.

150 W from a single channel

The listing gives a maximum power of 150 W for this model. With up to 5 A on tap, the Keithley 2200-30-5 power supply handles loads that smaller bench units cannot. For instance, a motor driver board, a relay panel or an LED module can run at a realistic load. So you test the product under conditions close to the factory floor. The listing names USB and GPIB, which lets a PC log and repeat each run.

Keithley 2200-30-5 power supply at a glance

Item Value
Product type Single-channel programmable DC power supply
Outputs 1
Maximum voltage 30 V
Maximum current 5 A
Maximum power 150 W
Connectivity USB and GPIB

Use the table as a starting point, then ask for the current datasheet before you plan a fixture.

Short project or permanent bench?

Rent the Keithley 2200-30-5 power supply for an audit, a line bring-up or a design review that ends in a few weeks. Buy it when controller testing never stops. In both cases, request a quote from Lost in HCM and list your dates, accessories and site. The wider power supplies category shows other options, and the Tektronix site covers Keithley products. You can also contact SMK Vietnam.

Before the unit arrives, check the AC line option, your leads and the software on your PC. The Keithley manual sets out grounding rules and safe operating limits, so read it first.

2200-30-5 questions

Is 30 V enough for a 24 V device?

Usually yes, because 30 V leaves margin above a 24 V rail. Still, check the peak and start-up behavior of your own load.

Does it have more than one output?

No. The listing describes a single-channel unit with one output.

Can I buy it instead of renting?

Yes. Lost in HCM lists it for rental and sale, so say which you prefer when you ask for a quote.

Additional information

Brand

Keithley (Tektronix)

Supplied by

Lost in HCM (lostinhcm.com)

Reviews

There are no reviews yet.

Be the first to review “Keithley 2200-30-5 Power Supply, Single-Channel Programmable DC, 30 V, 5 A, 150 W”

Your email address will not be published. Required fields are marked *